Kenmore 15,000 BTU Multi-Room Air Conditioner Installationsanleitung PDF herunterladen

For Medium (15-18.5K) + Heavy duty (22-28.5K)Air Conditioner

READ BEFORE INSTALLING UNIT

To avoid risk of personal injury, property damage, or product damage due to the weight of this device and sharp

edges that may be exposed:

Air conditioners covered in this manual pose an excessive weight hazard. Two or more people are needed to

move and install the unit. To prevent injury or strain, use proper lifting and carrying techniques when moving unit.

Carefully inspect location where air conditioner will be installed. Be sure it will support the weight of the unit over

an extended period of time.

Handle air conditioner with care. Wear protective gloves whenever lifting or carrying the unit. AVOID the sharp

metal fins of front and rear coils.

Make sure air conditioner does not fall during installation.

If a new electrical outlet is required, have the outlet installed by a qualified electrician before installing unit.

NOTE: DO NOT USE ANY SCREWS OTHER THAN THOSE SPECIFIED HERE.

Preliminary instructions: window sash seal

Do the following before starting to install unit. See illustrations below.

Check dimensions of your unit to determine model type:

Heavy duty Medium

Capacity: 22,000~28,500 BTU 15,000~18,500 BTU

Unit Height: 18-5/8" 17-5/8"

Unit Width: 26-1/2" 23-5/8"

Min. Window Opening: 19-1/2" 18-1/2"

Min. Window Width: 31" 26-1/2"

Max. Window Width: 42" 40-1/2"

1. Check window opening size: the mounting parts

furnished with this air conditioner are made to install in

a wooden sill double-hung window. The standard parts

are for window dimensions listed above. Open sash to

a minimum of 19" (483mm). (FIG.l)

2. Check condition of window: all wood parts of window

must be in good shape and able to firmly hold the needed

screws. If not, make repairs before installing unit.

3. Check your storm windows: If your storm window

frame does not allow the clearance required, correct by

adding a piece of wood as shown (FIG.2), or by removing

storm window while room air conditioner is being installed.

FIG.1 _--sash

19" min

1/2" min inner sill |

safety lock and

3/4" long hex

head screw

foam gasket

washer head

locking

top angle

frame

(left)

storm window frame or

other obstruction

side retainer

1/2" tong

screws and

bottom rail Iocknuts -_

seat to unit %

/ Iocknut 3/4"\ rr__ window

• 1_ long flat ,,_.._ support bracket

head bolt \ ,=_

sill angle

"_ bracket

frame

assembly

(right)

FIG.2 _--sash

19" min

1/2" min i1-1/2" min /

-----f inner sill

board thickness as

I _ required, along entire inner

window sill; fasten to inner

storm window frame or sill with two nails or screws.

other obstruction

2020218A0645

1 2 3 4 5 6 7 8

Inhaltsverzeichnis

Seite 1 - READ BEFORE INSTALLING UNIT

For Medium (15-18.5K) + Heavy duty (22-28.5K)Air ConditionerREAD BEFORE INSTALLING UNITTo avoid risk of personal injury, property damage, or product d

Seite 2 - 32.vJ circumstances,cut

4. Check for anything that could block airflowCheck area outside of window for things such as shrubs, trees, or awnings. Inside, be sure furniture, dr

Seite 3 - ...__'__ II _ _

.2.is free, lift filter up and out.FIG.1 _ _.___F Front Grille_ /Window MountingRemove Air Conditioner from CabinetNOTE: Remove any packaging material

Seite 4 - Install Support Bracket

FIG.9 Top window fillerpanel legWINDOW FILLERPANELBottomfiller panel leg.SIDE RETAINERPlace Cabinet in WindowFIG.10TOP VIEWAIR CONDITIONER"I"

Seite 5 - SAFETYL°cK..__. ...__

Extend Window Filler Panels and attach to top angle rail:1. Carefully raise window to expose filler panel locking screws on top angle rail. Loosen scr

Seite 6 - Thru-The-Wall installation

Thru-The-Wall installation• Consult local building codes prior to installation, or a qualified carpenter.Select Wall LocationThis air conditioner slid

Seite 7 - Prepare and Install Cabinet

4. BuildawoodenframewiththeINSIDEdimensionsofyourmodellistedabove.(Measuretwiceremember...)Framedepthshouldbethesameaswallthickness.Fillinthespacefrom

Seite 8 - FIG.7 FIG.8

FIG.7 FIG.8iiiiii!iiiportbracketill L-z/ _'Sillanglebracket_ Wooden strip6. Install air conditioner into cabinet by following all steps in Step 9