OWNER'S MANUALPremierReverse Osmosis Drinking Water SystemMODEL NO. 625.385560Caution:Read and follow all safety rules and operating instructions
Step 2 - Install RO Drain In Remote LocationOutside Faucet (Hard Water)Soft, Cold Water Soft, Hot Water ^BLUE Tubing to Reverse Osmosis Air Gap Fauce
Step 3 - Install RO Filter AssemblyINSTALL REVERSE OSMOSIS FILTER ASSEMBLYThe Reverse Osmosis Filter Assembly can sit upright or lay on its side. When
Step 5 - Install RO FaucetSELECT LOCATION OF REVERSE OSMOSIS FAUCET MOUNTING HOLEYou will need to select the location of the ReverseOsmosis Faucet. Yo
Step 5 - Install RO FaucetNOTE: If you ran the red reverse osmosis drain tubing directly to a remote drain point, disregard steps 5 and 6 and refer to
Step 6 - Connect TubesHOW TO CUT AND CONNECT THE TUBESYour Reverse Osmosis Water System includes push-in fittings for quick tubing connection.
Step 6 - Connect Tubes3/8” black tubingwater supply fitting1/4” red tubing 3/8” blue tubingNOTE: Tubing lengths should allow access to the back of the
Step 7 - Sanitize, Test and Purge SystemSANITIZE THE SYSTEMSanitizing is recommended immediately after installation of the Reverse Osmosis system. It’
Step 7 - Sanitize, Test and Purge SystemPRESSURE TEST THE SYSTEMNOTE: Complete the sanitizing procedures on the preceding page before pressure testin
How Your RO Water System WorksHOW YOUR REVERSE OSMOSIS SYSTEM WORKSIntroduction: Your Reverse Osmosis (RO) Drinking Water System uses your household w
How Your RO Water System WorksPRODUCT WATER FAUCETWATERINGREEN□PREFILTERf1fROMEMBRANEReverse Osmosis Water Flow SchematicWater Flow Description1. Wate
WarrantyKENMORE ELITE ONE YEAR FULL WARRANTYWhen installed, operated and maintained according to all supplied instructions, if this product fails due
MaintenancePREFILTER/POSTFILTER MAINTENANCENOTE: It is recommended to replace the battery, prefilter and postfilter cartridges at least every 6 months
MaintenanceCHANGE COLLET AND O-RING1. Remove the collet and o-ring from the fitting with a small screwdriver. Be careful not to scratc
SpecificationsSupply water pressure limits...
Questions? Call The Kenmore Water Line 1-800-426-9345 or visit KenmoreWater.com23
TroubleshootingProblem: Chlorine taste and/or odor In the RO product water.Cause: The level of chlorine in your watersupply exceeds maximum limits, an
TroubleshootingProblem: Water leaking from faucet airgap hole.Cause: Drain side of faucet airgap (3/8” black tubing) plugged, restricted or
Exploded ViewQuestions? Call The Kenmore Water Line 1-800-426-9345 or visit KenmoreWater.com26
Parts ListKey No. Part No. Description17273337Screw (6 req’d)27281330Washer (4 req’d)3 7273345Automatic Shut Off Cover47272658Check Valve57115432 O-ri
Get it fixed, at your home or ours!Your HomeFor expert troubleshooting and home solutions advice:@managemylifewww.managemylife.comFor repair - in your
Table of ContentsUnpack and Check Shipment ...
Unpack and Check Your CartonINSPECT SHIPMENTYour Reverse Osmosis Drinking Water System is shipped complete in one carton. Remove all items from your s
What Your Reverse Osmosis System Will DoYour Reverse Osmosis (RO) Drinking Water System is a water treatment unit. It uses household water pressure to
Plan Your InstallationFigure 2Typical Remote InstallationFigure 3Questions? Call The Kenmore Water Line 1-800-426-9345 or visit KenmoreWater.com6
Overview and Site PreparationOVERVIEWThere are seven easy steps to installing your Drinking Water system. They ore os follows:STEP 1 - Install
Step 1 - Install Supply Water FittingCHOOSE TYPE OF WATER FITTING TO INSTALLCheck and comply with local plumbing codes as you plan, then install o col
Step 2 - Install RO Drain Under SinkINTRODUCTIONA suitable drain point is needed for the reject water from the Reverse Osmosis Filter. You have two op
Kommentare zu diesen Handbüchern